DIY Jeep Rock Sliders
I needed some way to jack my Jeep up from the side, using a Farm Jack. The sheet metal was way to thin, and would get crushed all most instantly. So I was looking at rock sliders, I found some cheap ones….but not cheap enough 🙂
I embarked on making my own. I went to a local recycling company, and bought 1/4″ think 5″x3″ angle iron. It was $.35 per pound.
I used my plasma cutter to cut the angle to match the front and rear fender flares. Drilled and counter sunk for stainless steel hardware.
The whole project cost about $55 🙂
Comments are closed.